For general Tips and Hacks to make layering decals simple, click here.
Step 1:
Clean your MagicBand with the alcohol wipe included with your decals. Cut the white jewel apart from the white collar decal.
Step 2:
Peel the white backing off the teal Mickey decal. Using the clear transfer tape, place the Mickey on the MagicBand.
Step 3:
Remove the transfer tape by peeling it off. If the decal starts to lift off, press it back down.
Step 4:
Peel the white backing off the green pants decal. Place the decal on the bottom half of the Mickey decal, lining up the bottom edges.
Step 5:
Remove the transfer tape by peeling it off. If the decal starts to lift off, press it back down.
Step 6:
Peel the white paper backing off the yellow jacket decal. Place it on the big circle of the Mickey, aligning the edges.
Step 7:
Remove the transfer tape by peeling it off. If the decal starts to lift off, press it back down.
Step 8:
Peel the white paper backing off the green hat decal. Using the transfer tape, place it at the top of the Mickey.
Step 9:
Remove the transfer tape by peeling it off. If the decal starts to lift off, press it back down.
Step 10:
Peel the white backing off the teal stripe decal. Place it just above the brim of the hat, aligning the edges.
Step 11:
Remove the transfer tape by peeling it off. If the decal starts to lift off, press it back down.
Step 12:
Peel the white backing off the white card decal. Place it on the hat, covering the teal stripe, aligning it with the edge of the hat.
Step 13:
Remove the transfer tape by peeling it off. If the decal starts to lift off, press it back down.
Step 12:
Peel the white backing off the blue bow tie decal. Place it on Mickey, just below the hat.
Step 15:
Remove the transfer tape. You're done!
For more decals like this one, check out TheMousierge shop on etsy!
Comments