For general Tips and Hacks to make layering decals simple, click here.
Step 1:
Clean your MagicBand with the alcohol wipe included with your decals. If you did not purchase a sun decal, skip down to the vine instructions below, at Step 8. Turn over the four parts of the sun decal, you'll notice they are numbered 1-4 on the back. This will help you to know where each quarter of the decal is placed around the puck.
IF YOU PURCHASED THE MAGICBAND+ VERSION OF THIS DECAL, SKIP TO STEP 8
Step 2:
Peel the white backing off the yellow sun decal marked #1 on the back. Using the transfer tape, place it on the top right corner of the puck.
Step 3:
Remove the transfer tape by peeling it off. If the decal starts to lift off, press it back down.
Step 4:
Repeat this process with decal #2 on the top left corner of the puck.
Step 5:
Peel off the transfer tape and then continue by placing decal #3 in the bottom left corner of the puck.
Step 6:
Finish the sun decal by adding #4 to the bottom right corner.
Step 7:
Remove the transfer tape by peeling it off. If the decal starts to lift off, press it back down. You're finished with the sun! Skip to step 11.
Step 8:
Peel the white backing off the yellow sun decal marked TOP on the back. Using the transfer tape, place it on the top of the puck.
Step 9:
Remove the transfer tape by peeling it off. If the decal starts to lift off, press it back down.
Step 10:
Peel the white backing off the yellow sun decal marked BOTTOM on the back. Using the transfer tape, place it on the top of the puck. Remove the transfer tape.
Step 11:
Peel the white paper backing off one of the vines. Using the transfer tape, place it on the side of the band. You can line it up to avoid certain holes as needed.
Step 9:
Remove the transfer tape by peeling it off. If the decal starts to lift off, press it back down.
Step 10:
Peel the white paper backing off the second vine decal. Using the transfer tape, place it on the band. Remove the transfer tape.
Step 11:
Begin placing the suns with the transfer tape. Place each sun at the end of the vine.
Step 12:
There should be six suns on each side.
Step 13:
Repeat the process on the other side of the band.
Step 14:
It should look like this when completed.
Step 15:
Congratulations! You're done!
For more decals like this one, check out TheMousierge shop on etsy!
