Layering Your Qui Gon Jinn MagicBand Decal

Available at The Mousierge shop on etsy

For general Tips and Hacks to make layering decals simple, click here.

Step 1:

Clean your MagicBand with the alcohol wipe included with your decals. Cut the white jewel apart from the white collar decal.

Step 2:

Peel the white backing off the black Mickey decal. Using the clear transfer tape, place the Mickey head on the MagicBand.

Step 3:

Remove the transfer tape by peeling it off. If the decal starts to lift off, press it back down.

Step 4:

Peel the white backing off the brown robe decal. Place the decal at the sides of the Mickey with the wider opening at the bottom.

Step 5:

Remove the transfer tape by peeling it off. If the decal starts to lift off, press it back down.

Step 6:

Peel the white paper backing off the beige robes decal. Place it between the brown robes.

Step 7:

Remove the transfer tape by peeling it off. If the decal starts to lift off, press it back down.

Step 8:

Peel the white paper backing off the black lightsaber hilt decal. Using the transfer tape, place it so it is near the bottom of the Mickey on the right or left side. It should be angled so it points to the middle of the ear on the opposite side.

Step 9:

Remove the transfer tape by peeling it off. If the decal starts to lift off, press it back down.

Step 10:

Peel the white backing off the green lightsaber blade decal. Place it so it meets the hilt and points up.

Step 11:

Remove the transfer tape. You're done!

For more decals like this one, check out TheMousierge shop on etsy!