Layering Your Prince Ferdinand MagicBand Decal

Available at The Mousierge shop on etsy

For general Tips and Hacks to make layering decals simple, click here.

Step 1:

Clean your MagicBand with the alcohol wipe included with your decals.

Step 2:

Peel the white backing off the blue decal. Using the clear transfer tape, place it on the Mickey on the MagicBand. The point should line up with the top of the Mickey head, between the ears. The rounded part will match the round bottom of the Mickey.

Step 3:

Remove the transfer tape by peeling it off. If the decal starts to lift off, press it back down.

Step 4:

Peel the white backing off the dark red ears decal. Place the decal on the Mickey ears. It will match up with the edge of the blue decal.

Step 5:

Remove the transfer tape by peeling it off. If the decal starts to lift off, press it back down.

Step 6:

Peel the white paper backing off the brown belt decal. Using the transfer tape, place it across the Mickey. The sides will match the curve of the Mickey.

Step 7:

Remove the transfer tape by peeling it off. If the decal starts to lift off, press it back down.

Step 8:

Peel the white paper backing off the yellow decolletage & belt buckle decal. Using the transfer tape, place it so the belt buckle is in the middle of the belt. The decolletage will line up with the sides of the Mickey.

Step 9:

Remove the transfer tape. You're done!

For more decals like this one, check out TheMousierge shop on etsy!